How to reset cisco 2950 switch to default settings

#How to reset cisco 2950 switch to default settings password#
#How to reset cisco 2950 switch to default settings Pc#

C2955 Boot Loader (C2955-HBOOT-M) Version 12.1(0.0.514), CISCO DEVELOPMENT TESTД«ase ethernet MAC Address: 00:0b:be:b6:ee:00ДЇlashfs: 0 orphaned files, 0 orphaned directoriesД«oot Sector Filesystem (bs:) installed, fsid: 3

The example below uses Hyperterm to break into switch: mode on a 2955.

#How to reset cisco 2950 switch to default settings password#

For more information, refer to Standard Break Key Sequence Combinations During Password Recovery. On a workstation running UNIX, Ctrl-C is the break key. Hyperterm running on Windows 2000 uses Ctrl + Break. The break sequence is determined by the terminal application and operating system used. Instead the switch boot loader uses the break-key detection to stop the automatic boot sequence for the password recovery purposes.

The Catalyst 2955 series switches do not use an external mode button for password recovery. Note: LED position may vary slightly depending on the model. When you release the Mode button, the SYST LED blinks green. Release the Mode button after approximately 15 seconds when the SYST LED turns solid green. Release the Mode button when the SYST LED blinks amber and then turns solid green. When you release the Mode button, the SYST LED blinks amber. Release the Mode button after approximately 5 seconds when the Status ( STAT) LED goes out. Release the Mode button when the LED above Port1x goes out. LED Behavior and Mode Button Release Action

Hold down the mode button located on the left side of the front panel, while you reconnect the power cable to the switch. Note: For additional information on cabling and connecting a terminal to the console port, refer to Connecting a Terminal to the Console Port on Catalyst Switches.

#How to reset cisco 2950 switch to default settings Pc#

Attach a terminal or PC with terminal emulation (for example, Hyper Terminal) to the console port of the switch.Use the following terminal settings:.Step-by-Step ProcedureДЇollow the password recovery procedure below. There are no specific prerequisites for this document. Before You Begin ConventionsДЇor more information on document conventions, see the Cisco Technical Tips Conventions. This document describes the password recovery procedure for the Cisco Catalyst Layer 2 fixed configuration switches 2900XL/3500XL, 2940, 2950/2955, 2960, and 2970 Series, as well as the Cisco Catalyst Layer 3 fixed configuration switches 3550, 3560, and 3750 Series.